Home > Formula 1 2014, Red Bull RB10 Renault > Red Bull RB10 Renault – Launch analysis

Red Bull RB10 Renault – Launch analysis


  The new RB10 was launched on 28/01/2014 in Jerez Track and it is  product of hard work out of clean sheet . Key spots analysis follows

 RB10 keys spots small

1.At front the nose structure differs somehow from the finger extension design, having an elegant thin keel extension, very similar to the one seen a decade ago when cars still had single keel chassis to hold the front suspension’s lower wishbones . The overall nose stands closer to the ground , flat on top but bulgy underneath to stimulate the front wing’s efficiency as front wing holds to the nose via smaller pillars .

2. Front wing remains highly complicated, and transforms from a four-element wing to a six-element close to the endplates . Under flaps vanes, hard to observe, look very sophisticated either.

3. The S Duct inside the nose cone, just in front of the bulkhead, remains on RB10, but of course adjusted to altered  aero demands of 2014 . It helps to discourage flow detachment that takes place under the nose . Possibly the same system is capable of providing additional cooling solutions for nose housed electronics or even for cockpit ventilation.

 Redbull_RB10_front end small

4. As expected sidepod openings took special treatment so as to both provide additional cooling in 2014 and sustain an optimum aerodynamic silhouette. Sidepod tunnels look still very tight, highly sculpted at bottoms with a completely different end which closes smoothly to the car’s centerline having now lost the exhaust Coanda ramps and the tunnels underneath them .

 Redbull_RB10_sidepod inlets small

5.Inside the RB10  a completely new packaging of ERS batteries, radiators, electronics and engine parts took place under the skin compared to previous RB9 .

6. An extra rectangular cooling inlet absent on RB9 and smaller to the analogous seen on Toro Rosso STR9,  exists under the airbox main opening. Furthermore that zone continues to be very sculpted for keeping drag as low as possible.

 RB10 airbox

7. Rear wing is supported  via a single support onto the car’s body, just above the engine funnel. For easier wing assembling that  support is attached on a base extension a few centimeters above the engine cover . It is uncertain if DRS components are now housed inside that pillar, but that would be the logical step as beam wing, useful for connecting the system via the endplates to the car, is now absent. Furthermore such a configuration is simpler and less vulnerable to malefactions.

 RB10 rear wing small

 8.  The single exhaust terminal pipeline is housed inside the oval shaped engine cover’s funnel, with the latest to be a common feature on all recent Red Bull cars .

All images credited to Red Bull Racing 

 

 

 

  1. No comments yet.
  1. No trackbacks yet.

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s

%d bloggers like this: